After collecting over 4.3 million Automatic Dependent Surveillance - Broadcast (ADS-B) messages from aircraft since it launched in September 2016, the 3.5 kilogram 10x10x34cm CanX-7 nanosatellite deployed its four drag sails yesterday evening. CanX-7 was built by Space Flight Laboratory (SFL) at the University of Toronto Institute for Aerospace Studies (UTIAS).

Each drag sail has an area of approximately one square meter. The sails are intended to decrease the ballistic coefficient of the satellite and use atmospheric drag to accelerate orbital decay.

The drag sail technology is important for nano- and microsatellites whose low Earth orbital presence would exceed the Inter-Agency Space Debris Coordination Committee (IADC) guidelines that limit such presence to 25 years after end of mission.

"With SFL's innovative drag sail technology verified on orbit, the door is opened to using this technology on future missions where compliance to IADC guidelines would not otherwise be possible," says Robert Zee, Director of SFL, "Such compliance is essential to ensuring that space debris is mitigated for the world. It is also a critical component in satisfying regulatory bodies so that small satellite missions may proceed uninhibited."

CanX-7 completed a seven-month campaign to collect ADS-B messages from aircraft to demonstrate Canada's first ADS-B data collection from space. With that phase of the mission successfully completed, the drag sails were deployed to begin the second phase of the mission.

The sequential phases were intended to emulate an operational mission followed by deorbiting. A key component in the drag sail technology demonstration was long-term stowage of the drag sail modules in space without interrupting or affecting the operational mission.

"We want our drag sail technology to be compact and non-intrusive to a satellite's main mission. This will ensure wide acceptance and easy adoption by future microsatellite missions," says Zee.

"The four drag sails were deployed across the two passes this evening (two sails per pass)," reported Brad Cotten, CanX-7 Project Manager on May 3. "All telemetry is nominal and indicates that each sail is fully deployed. The deployment was also confirmed optically from the ground."

During this final phase of the CanX-7 mission, the deorbiting process will be closely monitored via the SFL ground station in Toronto. Orbital decay rate will be determined and compared against pre-launch simulation results.

"We are thankful to our sponsors that helped make this mission successful for the benefit of Canada and the world, including Defence R and D Canada - Ottawa, the Natural Sciences and Engineering Council of Canada, COM DEV, Royal Military College of Canada, and the Canadian Space Agency," said Zee.

Tweet

NASA Selects Arkansas' First CubeSat
Fayetteville, AR (SPX) May 04, 2017
Arkansas' first CubeSat, a small satellite selected by NASA for space education and research, will observe the Earth's climate and measure the composition and concentration of atmospheric gases. In February, NASA announced the selection of ArkSat-1 as one of 34 satellites from 19 states and the District of Columbia that will be launched into space between 2018 and 2020. ArkSat-1 is being d ... read more

Related Links
Space Flight Laboratory
Microsat News and Nanosat News at SpaceMart.com

Thanks for being here; We need your help. The Space Media Network continues to grow but revenues have never been harder to maintain. With the rise of Ad Blockers, and Facebook - our traditional revenue sources via quality network advertising continues to decline. And unlike so many other news sites, we don't have a paywall - with those annoying usernames and passwords. Our news coverage takes time and effort to publish 365 days a year. If you find our news sites informative and useful then please consider becoming a regular supporter or for now make a one off contribution.
SpaceMediaNetwork Contributor $5 Billed Once credit card or paypal		SpaceMediaNetwork Monthly Supporter $5 Billed Monthly paypal only